Power Management This item acts like a master switch for the power-saving modes and hard disk timeouts. Pin 1 to the right: When the power button is pressed for longer than 4 seconds, the system will enter Soft-Off mode. The combination shown as follows. Remove jumper cap from pins If it is set to User Define, you can insert your own timeouts for the power-saving modes. Microsoft and Windows are registered trademarks of Microsoft Corporation.

Uploader: Vudojind
Date Added: 26 December 2018
File Size: 62.35 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 42095
Price: Free* [*Free Regsitration Required]

It is recommended that you leave this item at the default value. You need to purchase a heatsink and fan if they are not bundled with your CPU.

Y Pressing ‘Y’ loads a set of best-performance default values. Setup Items The main menu includes the following main setup categories. Password Check If you have entered a password for the system, use this item to deter mine, if the password is required to enter the Setup Utility Setup or required both at start up and to enter the Setup Utility Always.

C] Install Audio Driver [4.

Shuttle AV49PN VIA PT Socket ATX MB w/SATA (AV49PN) Motherboard |

When putting the mainboard down, place it on top of its original raaid film, on an even surface, and components side up. Power Management Setup Use this menu to specify your settings for power management. Driving Use this item to signal driving current on AGP cards to auto or manual. Wear an antistatic wrist strap or take other suitable measures to prevent electrostatic discharge ESD whenever handling this equipment.


Shuttle Computer AV49P/N Free Driver Download (Official)

CPU Pin 1 and cut edge 3. These default values are quite demanding and your system might not function properly if you are using slower memory chips or other low-performance components. Microsoft and Windows are registered trademarks of Microsoft Raud. Referring to the following mainboard layout helps you identify various jumpers, connectors, slots, and ports.

Free Download Shuttle AV49P N RAID Driver – Shuttle AV49P N RAID Driver download

In most computer housings, you can find 4 or more holes to place studs for fixing the mainboard. Once you made your selection, a Setup window run the installation automatically. Trademarks Shuttle is a registered trademark of Shuttle Inc. Position the studs between the chassis and the mainboard.

Connect IDE cable and FDD cable on the back panel of the internal peripheral devices to the corresponding headers on board. Steps described herein will lead you to a quick and correct installation of your system. These default values are not very demanding and they should allow your system to function with most kinds of hardware and memory chips. SelfMonitoring, Analysis and Reporting Technology feature.

The total system memory is calculated by simply adding up the rid in all DIMM banks.

System fan connector CD2: If there aren’t enough matching holes, screw at least 4 studs to ensure the proper attachment of the mainboard. Building your own computer system is not as difficult as you may think.


Two mini jumpers must be setted on pins and pinswhen this header is not used. Note that the cable should be oriented with its colored stripe usually red or magenta connected av499p pin 1 both on the mainboard IDE or FDD connector and on the device as rais.

Shuttle AV49P/N RAID Driver For Windows 98/ME/2000/XP Free Download

When completed, new code takes effect. Auto, Enabled or Disabled. Please refer to page 24 on clear CMOS setting.

These default values are quite demanding and your system might not function properly if you are using slower chips or other rais components. If the over-clocking fails, please turn off the system power. When the copying files is done, make sure you reboot the system to take the installation effect.

When this item is not disabled and after the setup time of system inactivity, all devices except the CPU will be shut off. You may find there are a lot of mounting holes on your computer chassis and mainboard. Front panel audio header SPK1: